Manitowoc QD0672C Specifications download pdf (Page 45)

Section 4 Maintenance

Part No. 80-1175-3, 6/03 4-7

REMOVAL OF PARTS FOR CLEANING/SANITIZING

1. Turn off the water supply to the ice machine at the

water service valve.

2. Remove the water curtain and the components you

want to clean or sanitize. See the following pages for

removal procedures for these parts.

3. Soak the removed part(s) in a properly mixed

solution.

4. Use a soft-bristle brush or sponge (NOT a wire

brush) to carefully clean the parts.

5. Use the solution and a brush to clean the top, sides,

and bottom evaporator extrusions; the inside of the

ice machine panels; and the entire inside of the bin.

6. Thoroughly rinse all of the parts and surfaces with

clean water.

7. Install the removed parts.

NOTE: Incomplete rinsing of the ice thickness probe or

water level probe may leave a residue. This could cause

the ice machine to malfunction. For best results, brush or

wipe the probes off while rinsing it. Thoroughly dry the

probes before installing them.

8. Turn on the water and electrical supply.

9. Verify the ice thickness probe is properly adjusted.

Warning

Disconnect electric power to the ice machine at the

electric switch box before proceeding.

Warning

Wear rubber gloves and safety goggles (and/or face

shield) when handling Ice Machine Cleaner or

Sanitizer.

Caution

Do not mix Cleaner and Sanitizer solutions together.

It is a violation of Federal law to use these solutions

in a manner inconsistent with their labeling.

Solution Type Water Mixed With

Cleaner 1 gal. (4 l) 16 oz (500 ml) cleaner

Sanitizer 4 gal. (15 l) 1 oz (30 ml) sanitizer

Caution

Do not immerse the water pump motor in the

cleaning or sanitizing solution.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 53 54

No comments

Manitowoc QD0672C Specifications Page 45